Beschreibung
Weight is the only currency that matters above the treeline. Every gram you carry uphill has to be justified, and the oldest justification in camping is the one nobody argues with: a shelter that stays put. Steel pegs hold well and cost weight you feel by the second hour. Aluminium pegs save the weight and bend on the first rock. Titanium is the only material that refuses the trade-off, which is why the Titan Anchor set exists in 3.0mm titanium alloy with a formed hook head rather than a stamped notch.
Each peg runs 165mm from tip to hook, long enough to reach below the loose surface layer into ground that actually grips. The 3.0mm shaft carries a tapered point that enters packed soil without a mallet, and the hook keeps a guy line seated instead of sliding up the shaft when the wind changes direction at three in the morning. Eight pegs make a complete loadout for a one or two person tent, and the entire set travels under a hundred grams, so the weight argument disappears from the packing list entirely.
The finish is not decoration. Raw titanium and anodised colour batches both carry a hard oxide surface that resists the abrasion that eventually strips painted steel down to rust. Nothing about this set is designed to be admired at base camp. It is designed to be forgotten in the ground, retrieved the next morning, and packed out without a second thought, season after season.
An anchor is not equipment. It is the reason you sleep instead of standing watch.
What Titanium Actually Buys You
- ✦ 3.0mm titanium alloy shaft with a tapered ground entry point that bites without a mallet.
- ✦ 165mm working length reaches beneath loose topsoil into load-bearing ground.
- ✦ Formed hook head holds guy lines at tension instead of letting them ride up the shaft.
- ✦ Eight-piece set covers a one or two person pitch with spares for exposed ground.
- ✦ Full set travels under 100 grams, so the shelter budget stays honest.
- ✦ Raw titanium and anodised colour batches, both abrasion-resistant and rust-free.
- ✦ Corrosion-proof in rain, salt spray and winter mud, with no painted coating to chip.
Technical Specifications
- Material: Titanium alloy
- Shaft diameter: 3.0 mm
- Overall length: 165 mm
- Head type: Formed hook, guy-line retention
- Set size: 8 pegs
- Unit weight: Approximately 12 g per peg
- Total set weight: Under 100 g
- Finish options: Raw titanium / anodised colour
- Intended shelter: 1 to 2 person tents, tarps, bivy setups
- Best ground: Packed soil, gravel, grass, sand with rock weighting
Where This Set Earns Its Place
Backpackers counting grams on a multi-day traverse, bikepackers who need stakes that survive being strapped to a frame, and tarp campers who pitch and repitch as weather shifts. The set also suits emergency kits and vehicle bags where a stake may sit unused for a year and still has to work the day it is needed, which is precisely the case painted steel fails.
Field Questions
Do titanium pegs bend in rocky ground?
Titanium flexes further than aluminium before it takes a permanent set, and it springs back. On genuinely rocky ground you still reposition the peg rather than forcing it, and the hook head lets you weight the line with a rock when the ground refuses to hold anything.
Will these work in soft sand?
A 165mm peg is long enough for firm sand and beach grass. In loose dune sand, bury the peg horizontally as a deadman anchor and the load transfers to the soil above it, which is the same technique used with wide sand stakes.
What does the full set weigh?
Roughly 12 grams per peg, so eight pegs land under 100 grams total. That is less than a single steel stake of comparable length.
Do the coloured versions lose their finish?
The anodised layer is part of the oxide surface rather than a coating, so it wears gradually at the point where metal meets rock instead of flaking. Function is unaffected either way.
Is a mallet required?
No. The tapered point takes body weight to set in packed soil. A rock works as a driver on hard ground, and the hook head protects the shaft top.
How many pegs does one tent need?
A typical one or two person tent uses six to eight pegs across the corners and vestibule. The set of eight covers the pitch with spares for a windward side.
How do I pull a peg out of hard ground?
Hook a finger under the formed head and lever against the shaft rather than pulling straight up. Titanium returns to true, so a slight flex during removal costs nothing. In frozen ground, work the peg in a small circle before lifting it.
Will the hook fit standard guy line cord?
The hook throat takes 2mm to 4mm cordage, which covers the reflective guy lines sold with most lightweight tents and tarps. Thicker shock cord should be looped over the shaft instead of seated in the hook.
Customer Reviews
Payment and Security
Ihre Zahlungsinformationen werden sicher verarbeitet. Wir speichern keine Kreditkartendaten und haben keinen Zugriff auf Ihre Kreditkarteninformationen.